- 您现在的位置：买卖IC网 > Sheet目录341 > MAX662EVKIT-SO (Maxim Integrated Products)EVAL KIT FOR MAX662
MAX662A Evaluation Kit
_______________General Description
The MAX662A evaluation kit (EV kit) is an assembled
surface-mount board that allows easy evaluation of the
MAX662A or MAX662. The EV kit schematic is the stan-
dard circuit shown in Figure 3a on page 5 of the
MAX662A data sheet. A 3-pin jumper connector and a
shunt are included to allow easy control of normal-oper-
ation and shutdown modes.
______________Ordering Information
___________________PC Board Layout
The EV kit printed circuit board layouts (Figures 2 and
3) can be copied directly and incorporated into produc-
tion boards.
PART
MAX662AEVKIT-SO
TEMP. RANGE
0°C to +70°C
BOARD TYPE
Surface Mount
____________________Component List
DESIGNATION
QTY
DESCRIPTION
C1, C2
C3
C4, C5
J1
None
U1
None
None
2
1
2
1
1
1
1
1
0.22μF ceramic SMD chip
capacitors
0.1μF ceramic SMD chip
capacitor (MAX662 only)
4.7μF low-ESR tantalum
capacitors
3-pin jumper
Shunt
MAX662ACSA
MAX662A data sheet
1.5" x 1.1" PC board
Figure 1. MAX662A EV Kit Surface-Mount Component
Placement Diagram (1x scale)
____________Operating Instructions
Pin 1 of the 3-pin jumper connector is tied to ground,
pin 2 is tied to the SHDN pin of the MAX662A, and pin 3
is tied to V CC (Figure 1). Connect the jumper shunt
across pins 1 and 2 of jumper connector J1 for normal
operation. Note: The MAX662A EV kit will be in shut-
down mode if the jumper shunt is not inserted
across J1. The SHDN pin has an internal pull-up to
V CC , and therefore must be connected to ground for
proper operation. Connect the jumper shunt across
jumper connector pins 2 and 3, or simply remove the
jumper shunt to observe shutdown-mode operation.
Observe the power-supply input voltage limits specified
in the data sheet. Do not short the output to ground.
Also, do not excessively load the output—V OUT should
not fall below V CC . If the above conditions are violated,
the device may be damaged.
Figure 2. MAX662A EV Kit PC Board Layout—Component
Side (1x scale)
Figure 3. MAX662A EV Kit PC Board Layout—Solder Side
(1x scale)
________________________________________________________________ Maxim Integrated Products
For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642,
or visit Maxim’s website at www.maxim-ic.com.
1
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
MAX6947ATE+T
IC LED DRIVER LINEAR 16-TQFN
MAX6948BGWA+T
IC LED DVR PWM GPIO 25WLP
MAX6964ATG+T
IC LED DRIVER LINEAR 24-TQFN
MAX6965ATE+T
IC LED DRIVER LINEAR 16-TQFN
MAX6967ATE+
IC LED DRIVER LINEAR 16-TQFN
MAX6968AAE+
IC LED DRIVER LINEAR 16-SSOP
MAX6970AUE+
IC LED DRIVER LINEAR 16-TSSOP
MAX6971AUG+T
IC LED DRIVER LINEAR 24-TSSOP
相关代理商/技术参数
MAX6630MTT+
制造商:Maxim Integrated Products 功能描述:TEMP SENSOR DGTL 3-WIRE/SPI 6TDFN EP - Rail/Tube
MAX6630MTT+T
功能描述:板上安装温度传感器 12-Bit + Sign Temperature Sensor RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6630MUT
制造商:Maxim Integrated Products 功能描述:12-BIT + SIGN DIGITAL TEMPERATURE SENSORS WIT - Rail/Tube
MAX6630MUT#G16
制造商:Maxim Integrated Products 功能描述:12-BIT + SIGN DIGITAL TEMPERATURE S - Rail/Tube
MAX6630MUT#TG16
功能描述:板上安装温度传感器 12-Bit + Sign Temperature Sensor RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6630MUT#TGF6
功能描述:板上安装温度传感器 12-Bit + Sign Temperature Sensor RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6630MUT+T
功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX6630MUT-T
功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
